`98 outback subframe spacers

[turbo1600]

after doing a body lift , it kinda looks like the cv`s are too much of a angle, but drives fine ...
i was thinking of a 1.5" spacer kit.
couple questions:

will i have to extend the steering shaft coupling ?

does the trans crossmember need spacing ?

where underneath do all the spacers go ?

mark

 

[Venom]

Have you done a body lift or strut top? A full body lift kit include the engine, transmission cross memebers and the rear diff cradle, driveshaft, rear trailing arms, and a steering column extension, etc.

I have a full 2" body lift kit from my 98 Liberty if you want it. If you replace the factory 1" outback spacers with my 2" you'll improve the CV angles.

 

[Venom]

Just seen your post on facebook. Yes HD springs plus 2" strut top lift is too much without some compensation with a body lift. Your outback will have factory 1" body lift, which if you swap out for 2" body lift should correct that.

 

[turbo1600]

Just seen your post on facebook. Yes HD springs plus 2" strut top lift is too much without some compensation with a body lift. Your outback will have factory 1" body lift, which if you swap out for 2" body lift should correct that.

sent you a pm.
mk